Notes on measuring site size of fixed furniture

1、 When Party A or Party A gets the design drawings, they should first ask them if there is any scene change. If not, you must check the drawings again, who can guarantee that the construction personnel on site will meet the requirements according to the drawings, or because of subcontracting and inconsistent with the drawings and other reasons. The first thing is to make sure you get the right layout.

2、 All the details found are not conducive to the installation and construction of fixed furniture, which should be carried out in time to make the construction party change, size, achieve unity and standardization. This step may be a good size ratio, more important, after all, the volume size is a bit of a technical live. We have done a good job in the past. We can play a very important role.

3、 Measure the size of the door: look at the record from the side. If the construction of the site is relatively standard, the best way is early, such as the ceiling, the ground is not ready, we must build consultation, determine the horizontal line, uniform size. If the black and white and written forms are changed, oral statements without any evidence become very passive. There is no standard in this field, which depends on personal practical experience. Each person's field level is different, and the problems they see are different, not in the presentation. In general, it's better to use the record size of the final stage of Excel form to come out, in the form of management, and optimize the table data according to the width of the wall. Unified several dimensions, convenient fixed furniture factory production, I personally 15 mm is the stage of division. To do these forms, you have to put some in the band indoors, which played a huge role in the later stage of installation.

If the site wall does tilt, it will be installed when the door box line occurs and the wall is not tight. Before that, it should talk well with the first part of the foreseeable things, let Party A to the scene. If Party A is not willing to pay the price, it shall be removed.

4、 The size of the paper: the number of square look at the lateral edge of the inspection record. In addition to the normal size, perpendicularity and flatness, special attention should be paid to the wall. The perpendicularity of the wall will directly affect the installation of the adjacent wood veneer, and the gap can not be made well. The effect of smoothing will be most obvious in the case of half ladle, it is easy to cause the upper end and lower end of flushing, and an arc condition is formed in the middle, which causes special effect.

5、 The amount of closet size: time must pay attention to the relationship between the wardrobe and the surrounding, general amount of the relationship between the wardrobe will be placed in the door, behind the door, such as how to deal with the relationship between and air conditioning, maintenance relationship port, relationship and control box. Finally, do not forget the height of the ceiling, the top is generally recommended to do the form of necking plate, which can be adjusted in case of size error. Structure, if it must be indomitable spirit, we must pay attention to whether the ceiling is a sagging phenomenon, if the ceiling sagging situation (the impact is different heights of left and right board of the wardrobe), should be based on the lowest point. When there is a gap in the wardrobe, the paint can be repaired, and the effect is good. By the way, if the glass sliding door wardrobe enters, then we must emphasize the calculation of the wardrobe, adjust the structure accordingly, and enhance its stability. I think 18 mm can cope with it. It has to be reinforced before it is used. To determine the installation manual sliding door height parameter generally refers to the sliding door hardware height from the roof of the wardrobe resulting in the height minus the wardrobe sliding door is generally 45 - 55mm.

Another problem needs to be mentioned: the wardrobe is generally placed close to the wall. If the wall and the back panel of the wardrobe can't be close to the wall, for example, the lower part is close to the wall, but it is a long distance, it can be designed for intervention. Solution: do not flush with the side and back rebounds, should maintain about 10 mm. That is, the backplane retracts. Therefore, even if it is revised, it is more convenient.